WHEEL ALIGNMENT SPECIFICATIONS & PROCEDURES

�1993 Nissan Sentra

1993 WHEEL ALIGNMENT Nissan Specifications & Procedures

NX & Sentra

*** PLEASE READ THIS FIRST ***

NOTE: Prior to performing wheel alignment, perform preliminary visual and mechanical inspection of wheels, tires and suspension components. See PRE-ALIGNMENT INSTRUCTIONS in WHEEL ALIGNMENT THEORY/OPERATION article in the GENERAL INFORMATION section.

WHEEL ALIGNMENT PROCEDURES

CAMBER, CASTER & TOE-IN ADJUSTMENT

NOTE: For camber, caster and toe-in adjustment, see Figs. 1 and 2. Illustrations given show typical adjustment points.

Fig. 1: Adjusting Front Toe-In Courtesy of Nissan Motor Co., U.S.A.

Fig. 2: Adjusting Rear Toe-In Courtesy of Nissan Motor Co., U.S.A.

TORQUE SPECIFICATIONS

TORQUE SPECIFICATIONS TABLE

��

Application Ft. Lbs. (N.m)

Adjusting Pin Lock Nut (F & R) ..................... 72-87 (98-118) Tie Rod Lock Nut .................................... 27-34 (37-46) Wheel Lug Nuts ..................................... 72-87 (98-118)

��

WHEEL ALIGNMENT SPECIFICATIONS

WHEEL ALIGNMENT SPECIFICATIONS TABLE (NX)

��

Application Preferred Range

Camber (1) Front ....................... -0.25 .................. -1 To 0.5 Rear ........................ -1.17 ............. -1.92 To -0.42

Caster (1) .................. 1.83 ................. 1.08 To 2.58

Toe-In (2) Front ..................... 0.08 (2) ........ 0.04-0.12 (1 To 3) Rear ...................... 0.04 (1) ... -0.04 To 0.12 (-1 To 3)

Toe-In (1) Front ........................ 0.2 .................. 0.1 To 0.3 Rear ......................... 0.1 ................. -0.1 To 0.3

Toe-Out On Turns (1)

Inner (1.6L)	.................	41	........................ .....
Inner (2.0L)	.................	35	........................ .....
Outer (1.6L)	.................	33	........................ .....
Outer (2.0L)	.................	30	........................ .....

(1): - Measurement in degrees.
(2): - Measurement in inches (mm).

��

WHEEL ALIGNMENT SPECIFICATIONS TABLE (SENTRA)

��

Application Preferred Range

Camber (1) Front ....................... -0.25 .................. -1 To 0.5 Rear ........................ -0.92 ............. -1.67 To -0.17

Caster (1) .................. 1.42 ................. 0.67 To 2.17

Toe-In (2) Front ..................... 0.08 (2) ..... 0.04 To 0.12 (1 To 3) Rear ..................... 0.04 (1) ..... -0.04 To 0.12 (-1 To 3)

Toe-In (1) Front ........................ 0.2 .................. 0.1 To 0.3 Rear ......................... 0.1 ................. -0.1 To 0.3

Toe-Out On Turns (1) Inner (1.6L) ................. 41 ........................ ..... Inner (2.0L) ................. 35 ........................ ..... Outer (1.6L) ................. 34 ........................ ..... Outer (2.0L) ................. 30 ........................ .....

(1): - Measurement in degrees.
(2): - Measurement in inches (mm).

��